混凝土攪拌車是一種特別車輛，并不是所有會(huì )開車的司機都會(huì )開攪拌車，如果操作不當或許會(huì )引起不必要的麻煩，所以接下來 的文章主要講一下在工作中需要注意的細節問題。

The concrete mixer truck is a special kind of vehicle. Not all drivers who can drive the mixer truck can drive it. If it is operated improperly, it may cause unnecessary trouble. So the next article will mainly talk about the details that need attention in work.

1、起動攪拌車之前，應把攪拌筒操作手柄放在“中止”方位。

1. Before starting the mixing truck, put the operating handle of the mixing drum in the "stop" position.

2、起動發動機后，應使攪拌筒在低速下滾動10分鐘左右，使液壓油溫度升到20℃以上方可作業。

2. After starting the engine, the mixing drum should be rolled at low speed for about 10 minutes to make the hydraulic oil temperature rise to above 20 ℃ for operation.

3、攪拌車在露天停放時，裝料前應將攪拌筒回轉，將積水和雜物排出，以確保后期使用時混凝土的質量。

3. When the mixing truck is parked in the open air, the mixing drum shall be rotated before loading to drain the accumulated water and sundries, so as to ensure the quality of concrete in later use.

4、攪拌車在運輸混凝土時，要確?；贩胖美喂?，避免因松動造成擺動，在跋涉中打傷行人或影響其它車輛正常運轉。

4. When transporting concrete, the mixer truck shall ensure that the sliding bucket is firmly placed to avoid swinging due to looseness, hurting pedestrians or affecting the normal operation of other vehicles.

5、攪拌車裝運攪拌好的混凝土時，攪拌筒轉速為2-10轉/分；在運輸過程中，平坦路面上攪拌筒轉速堅持2-3轉/分；行駛在側 傾坡度大于50的路面，或左右晃動較大的路面時，應中止攪拌旋轉，待路況 好轉后再恢復攪拌旋轉。

5. When the mixing truck is transporting the mixed concrete, the mixing drum speed is 2-10 rpm; During transportation, the speed of mixing drum shall be 2-3 rpm on the flat road; When driving on a road with a side slope greater than 50, or on a road with large left and right shaking, the mixing rotation shall be stopped, and the mixing rotation shall be resumed after the road conditions improve.

6、攪拌車在排出混凝土之前，應使攪拌筒在10-12轉/分的轉速下滾動1分鐘，再進行排料。

6. Before discharging concrete from the mixer truck, the mixing drum shall be rolled at 10-12 rpm for 1 minute before discharging.

混凝土攪拌車出料結束，應立即用隨車的軟管放水將進料口、出料斗及出料溜槽等部位沖刷潔凈，排去粘結在車身遍地的污 物及殘留混凝土，再向攪拌筒內注水150-200L的清水，在返回途中要讓攪拌 筒慢速滾動，以清洗內壁，避免殘余料渣附在筒壁 和攪拌葉上，并在再一次裝料前將廢水排掉。更多相關內容就來我們網站http://www.apstzs.com咨詢吧！

After the discharge of the concrete mixer truck, immediately use the hose attached to the truck to wash the inlet, discharge hopper, discharge chute and other parts clean, drain the dirt and residual concrete stuck on the vehicle body, and then fill the mixing drum with 150-200L of water. On the way back, let the mixing drum roll slowly to clean the inner wall, avoid the residual material slag attached to the drum wall and mixing blade, and drain the waste water before loading again. Come to our website for more relevant content http://www.apstzs.com Ask!